Hiland HLDS032-B

Ръководство за употреба на преносим настолен отоплител за тераса Hiland HLDS032-B

Model: HLDS032-B

1. Въведение

This manual provides essential information for the safe assembly, operation, maintenance, and troubleshooting of your Hiland HLDS032-B Portable Table Top Patio Heater. Please read all instructions carefully before use and retain this manual for future reference.

The Hiland HLDS032-B is a compact, portable propane-fueled heater designed for outdoor use, providing 11,000 BTUs of heat. It is suitable for placement on tabletops and can operate with either a 1lb propane tank or a 20lb propane tank (with an adapter hose, not included).

Hiland HLDS032-B Portable Table Top Patio Heater in stainless steel finish.
Image: The Hiland HLDS032-B Portable Table Top Patio Heater, showcasing its stainless steel finish and compact design.

2. Информация за безопасност

WARNING: For Outdoor Use Only. Do not operate this heater indoors or in enclosed spaces.

  • Винаги осигурявайте адекватна вентилация, когато работите с нагревателя.
  • Keep clear of combustible materials. Maintain a minimum clearance of 24 inches (61 cm) from sides and rear, and 36 inches (91 cm) from the top.
  • Този нагревател е оборудван с thermocouple and anti-tilt safety devices, which will automatically shut off the gas supply if the pilot flame extinguishes or the unit tips over.
  • Не съхранявайте и не използвайте бензин или други запалими пари и течности в близост до този или друг уред.
  • Propane gas is heavier than air and will settle in low areas. Ensure the area around the heater is clear of any potential ignition sources.
  • Always inspect the gas hose and connections for leaks before each use. Use a soapy water solution to check for bubbles.
  • Do not attempt to repair or alter the heater. Contact qualified service personnel for repairs.
  • Дръжте деца и домашни любимци далеч от нагревателя по време на работа.
  • Този продукт съдържа химикали, за които е известно в щата Калифорния, че причиняват рак и вродени дефекти или други репродуктивни увреждания (предупреждение по Предложение 65).

3. Съдържание на пакета

Verify that all components are present and undamaged before assembly. If any parts are missing or damaged, do not proceed with assembly; contact customer service.

  • Heater Head Assembly (Burner, Reflector, Screen Guard)
  • Основно тяло/корпус
  • Плоча
  • Heavy Weight Plate for Stability
  • Регулатор
  • Пакет с хардуер (винтове, гаечен ключ)
  • Ръководство за употреба

4. Монтаж и настройка

Follow these steps for proper assembly and initial setup of your patio heater.

4.1 Attaching the Base and Weight Plate

  1. Внимателно разопаковайте всички компоненти.
  2. Attach the heavy weight plate to the underside of the base plate using the provided hardware. This plate significantly enhances stability.
  3. Secure the main body/housing to the base plate.
Долна страна view of the heater base showing the heavy weight plate attached for stability.
Image: Underside of the heater base with the heavy weight plate installed. This plate adds crucial stability to the unit.

4.2 Installing the Propane Tank

The heater is designed to use a 1lb propane tank directly or a 20lb propane tank with an optional adapter hose (not included).

  1. Ensure the control knob is in the "OFF" position.
  2. Open the access door on the main body of the heater. This door provides easy access to the propane connection point.
  3. Connect the regulator to the propane tank. For a 1lb tank, screw it directly into the regulator. For a 20lb tank, connect the adapter hose to the tank and then to the regulator.
  4. Carefully place the propane tank inside the heater's housing. The regulator may tilt for easier installation.
  5. Затворете добре вратата за достъп.
Close-up of the heater's main body showing the open access door for propane tank installation.
Image: The access door on the heater's body, designed for convenient installation of the propane tank.
Close-up showing a 1lb propane tank being installed into the heater with the tilting regulator.
Image: A 1lb propane tank being connected to the tilting regulator inside the heater's housing.
Интериор view of the heater showing the propane connection point.
Изображение: Вътрешно view of the heater's base, illustrating the propane connection point for the tank.

4.3 Тестване за течове

Before first use and after every tank change, perform a leak test:

  1. Mix a solution of soapy water (50% soap, 50% water).
  2. Ensure the heater's control knob is OFF.
  3. Отворете крана на резервоара за пропан.
  4. Apply the soapy solution to all gas connections. If bubbles appear, there is a leak. Tighten connections or replace parts as necessary. Do not operate the heater if a leak is detected.

5. Инструкции за работа

This section details how to safely ignite and operate your Hiland patio heater.

5.1 Процедура на запалване

It is recommended to perform the initial ignition in low light conditions to clearly see the pilot flame.

  1. Уверете се, че вентилът на резервоара за пропан е напълно отворен.
  2. Push in the control knob and rotate it counter-clockwise to the "PILOT" position.
  3. While holding the knob in, press the red igniter button repeatedly until the pilot flame ignites. You may need to press it multiple times (up to 15-20 times) until you hear a click and see the pilot light.
  4. Once the pilot is lit, continue to hold the control knob in for at least 15-20 seconds. This allows the thermocouple to heat up and engage the safety valve. Releasing too soon will cause the pilot to extinguish.
  5. After holding, slowly release the control knob. The pilot flame should remain lit. If it extinguishes, repeat steps 2-4.
  6. To ignite the main burner, push in the control knob and rotate it further counter-clockwise to the "LOW" or "HIGH" position. The main burner should ignite.
Close-up of the control panel with the black control knob and red igniter button.
Image: The control knob and igniter button on the heater's body, used for starting and adjusting the flame.
Close-up of the protective heat screen surrounding the burner element.
Image: The protective heat screen, designed to prevent direct contact with the hot burner element during operation.

5.2 Регулиране на топлинната мощност

Rotate the control knob between "LOW" and "HIGH" to adjust the heat intensity as desired. The heater provides up to 11,000 BTUs of heat.

5.3 Изключване на нагревателя

  1. Rotate the control knob clockwise to the "OFF" position.
  2. Затворете клапана на резервоара за пропан.
  3. Оставете нагревателя да се охлади напълно, преди да го преместите или съхраните.

6. Поддръжка

Regular maintenance ensures safe and efficient operation of your heater.

  • Почистване: Избършете външните повърхности с мека, damp cloth. Do not use abrasive cleaners or solvents. Ensure the burner screen is free of debris.
  • Съхранение: When not in use for extended periods, disconnect the propane tank and store the heater in a dry, protected area.
  • Инспекции: Periodically check all gas connections and the hose for signs of wear, damage, or leaks.

7. Отстраняване на проблеми

Вижте този раздел за често срещани проблеми и техните решения.

проблемВъзможна причинаРешение
Нагревателят не свети.
  • Propane tank empty or valve closed.
  • Pilot light not igniting.
  • Термодвойката не е достатъчно загрята.
  • Gas pressure issue.
  • Check propane level and ensure tank valve is fully open.
  • Press igniter button repeatedly. Ensure control knob is held in at "PILOT" position.
  • Hold control knob in at "PILOT" for 15-20 seconds after pilot ignition.
  • Check regulator and hose for kinks or damage.
Pilot light ignites but does not stay lit.
  • Копчето за управление е освободено твърде рано.
  • Неизправна термодвойка.
  • After pilot ignition, hold control knob in for a full 15-20 seconds to allow thermocouple to heat.
  • Contact customer support for thermocouple replacement.
Ниска топлинна мощност.
  • Low propane level.
  • Control knob not set to "HIGH".
  • Сменете или напълнете резервоара с пропан.
  • Adjust control knob to desired heat setting.
Миризма на газ.
  • Изтичане на газ.
  • Immediately shut off gas at the tank. Perform a leak test with soapy water. Do not operate until leak is resolved.

8. Спецификации

Номер на моделаHLDS032-B
Топлинна мощност11,000 XNUMX BTU
Тип горивоPropane (1lb tank or 20lb tank with adapter)
Размери (Д х Ш х В)20.87" x 37.8" x 20.87"
ТеглоApproximately 1 pound (unit only, without propane tank)
Функции за безопасностThermocouple, Anti-Tilt Safety Device, Burner Screen Guard
СертификатиCSA одобрен

9. Гаранция и поддръжка

Hiland products include a one-year warranty against manufacturer defects. AZ Patio Heaters LLC maintains a complete line of replacement parts and a full-service repair center.

For warranty claims, replacement parts, or technical support, please contact Hiland customer service. Refer to your purchase documentation for contact details.