VEMER VE075800 HIPNOS Wall Thermostat

Въведение

The VEMER VE075800 HIPNOS is a daily programmable wall thermostat designed for precise temperature control in your home. It features 24 sliders for programming, battery power, and supports both ON/OFF and proportional regulation in Summer/Winter modes. Its LCD display shows the measured temperature and set program.

Фигура 1: Отпред view of the VEMER VE075800 HIPNOS Wall Thermostat.

1. Настройка

1.1. Инсталиране на батерията

The thermostat requires 2 x 1.5V AA alkaline batteries (not included). Open the battery compartment, insert the batteries, ensuring correct polarity, and close the compartment. The device features a low battery indicator.

1.2. Монтаж

The thermostat is designed for wall installation. It can be mounted directly on the wall or to cover a 3-module flush-mounted box. Ensure the mounting location is free from direct sunlight, drafts, or heat sources that could affect temperature readings.

Figure 2: Product dimensions and basic wiring diagram for installation.

1.3. Окабеляване

Wiring should be performed by a qualified professional. Refer to the wiring diagram provided in the packaging and on the device itself. The thermostat supports a 5A / 250V~ connection.

Фигура 3: Страна view of the VEMER VE075800 HIPNOS Wall Thermostat.

2. Инструкции за работа

2.1. Daily Programming with Sliders

The thermostat features 24 sliders, one for each hour of the day. To program the desired temperature for a specific hour, adjust the corresponding slider. The display will show the temperature associated with the current slider position. Push the slider up for a higher temperature, or down for a lower temperature.

Figure 4: Front panel of the thermostat showing the display, control knob, and 24 programming sliders.

Figure 5: Detail of the 24 sliders for hourly temperature programming.

2.2. Ръчно регулиране на температурата

Use the knob on the front panel to set the temperature for manual operation. This overrides the programmed settings temporarily.

2.3. Избор на режим

The thermostat supports ON/OFF or proportional regulation. It also features a Summer/Winter mode selection to adapt to different seasonal heating or cooling needs.

Figure 6: LCD display showing time, temperature, and various icons for operating modes (e.g., power, snowflake for cooling, flame for heating, set, clock, low battery, manual mode).

2.4. Programming Example Video

Video 1: This video demonstrates how to program the daily temperature settings using the sliders on a similar VEMER Hipnos thermostat. It shows opening the cover, adjusting sliders for each hour, and then closing the cover to activate the program.

3. Поддръжка

3.1. Смяна на батерията

When the low battery indicator appears on the display, replace the 2 x 1.5V AA alkaline batteries promptly to ensure continuous operation. Refer to section 1.1 for battery installation instructions.

3.2. Почистване

Clean the thermostat's exterior with a soft, dry cloth. Do not use abrasive cleaners or solvents, as these can damage the device's surface or internal components.

4. Отстраняване на проблеми

• No display or unresponsive: Проверете монтажа на батерията и сменете батериите, ако е необходимо.
• Неправилно отчитане на температурата: Уверете се, че термостатът не е изложен на пряка слънчева светлина, течение или източници на топлина.
• Отоплението/охлаждането не се активира: Verify that the desired temperature is set correctly and that the thermostat is in the appropriate operating mode (Summer/Winter). Check the position of the hourly sliders.
• Проблеми с програмирането: Ensure each slider is fully engaged in its desired position.

Ако проблемите продължават, консултирайте се с квалифициран техник.

5. Спецификации

6. Гаранция и поддръжка

For warranty information and technical support, please refer to the documentation included with your product or visit the official VEMER webсайт. Запазете касовата си бележка като доказателство за покупка при евентуални гаранционни рекламации.